Publications

Skip Navigation Links.
Recently Published
Expand per documenttypeper documenttype
Expand per Unitper Unit
Expand per Clusterper Cluster

Search for publications:


Limit search to the fields

ECN publication
Title:
Crystalline silicon cell performance at low light intensities
 
Author(s):
Reich, N.H.; Sark, W.G.J.H.M. van; Alsema, E.A.; Lof, R.W.; Schropp, R.E.I.; Sinke, W.C.; Turkenburg, W.
 
Published by: Publication date:
ECN Solar Energy 22-6-2009
 
ECN report number: Document type:
ECN-W--09-015 Article (scientific)
 
Number of pages:
11  

Published in: Solar Energy Materials & Solar Cells (Elsevier), , 2009, Vol.93, p.1471-1481.

Abstract:
Measured and modelled JV characteristics of crystalline silicon cells below one sun intensity have been investigated. First, the JV characteristics were measured between 3 and 1000W/m2 at 6 light levels for 41 industrially produced mono- and multi-crystalline cells from 8 manufacturers, and at 29 intensity levels for a single multi-crystalline silicon between 0.01 and 1000W/m2. Based on this experimental data, the accuracy of the following four modelling approaches was evaluated: (1) empirical fill factor expressions, (2) a purely empirical function, (3) the one-diode model and (4) the two-diode model. Results show that the fill factor expressions and the empirical function fail at low light intensities, but a new empirical equation that gives accurate fits could be derived. The accuracy of both diode models are very high. However, the accuracy depends considerably on the used diode model parameter sets. While comparing different methods to determine diode model parameter sets, the two-diode model is found to be preferred in principle: particularly its capability in accurately modelling VOC and efficiency with one and the same parameter set makes the two-diode model superior. The simulated energy yields of the 41 commercial cells as a function of irradiance intensity suggest unbiased shunt resistances larger than about 10 kOcm2 may help to avoid low energy yields of cells used under predominantly low light intensities. Such cells with diode currents not larger than about 10!9 A/cm2 are excellent candidates for Product Integrated PV (PIPV) appliances.

More Information:

Back to List